Since these posts I always start up, taxi, run up and depart always on the main tanks, once I'm at cruise altitude I switch to aux, preparing for an engine out.
I feel safer
 |
International Comanche Society A maintenance forum for ICS members to share knowledge and learn about their Comanche. Problems? - Contact Administrator at: Webmaster |
Changing fuel selectors during taxi, how long before switch
24 posts
• Page 2 of 2 • 1, 2
by Ben Ayalon » Mon Nov 23, 2009 7:12 pm
-
Ben Ayalon - ICS member
- Posts: 289
- Joined: Sat Jun 29, 2002 9:40 pm
- Location: UK
-
Zach Grant L1011jock - Technical Advisor
- Posts: 1404
- Joined: Mon Mar 22, 2004 4:35 pm
- Location: Indianapolis KEYE
by Ben Ayalon » Fri Nov 27, 2009 9:46 pm
-
Ben Ayalon - ICS member
- Posts: 289
- Joined: Sat Jun 29, 2002 9:40 pm
- Location: UK
by Ben Ayalon » Sat Nov 28, 2009 5:26 pm
Am not sure.
You run your engine(s) at high power during checks, than taxi to the hold, set up the aircraft for t/o and line up, only then you to full power. But that time you have used enough fuel to know if you have a problem or not. If the taxi is a long one you can change tanks during the taxi.
I guess that this pne is like "which oil is best".
Ben
You run your engine(s) at high power during checks, than taxi to the hold, set up the aircraft for t/o and line up, only then you to full power. But that time you have used enough fuel to know if you have a problem or not. If the taxi is a long one you can change tanks during the taxi.
I guess that this pne is like "which oil is best".
Ben
-
Ben Ayalon - ICS member
- Posts: 289
- Joined: Sat Jun 29, 2002 9:40 pm
- Location: UK
24 posts
• Page 2 of 2 • 1, 2
Return to Maintenance - Powerplant
Who is online
Users browsing this forum: No registered users and 2 guests