Hello
Our 1959 Comanche 250 (N84VK), based in the UK, is currently undergoing its Annual maintenance. All was going very well until it was decided that the aircraft needed a replacement shimmy damper. I have been told that these are difficult to locate and that there is only one company manufacturing the part (approx cost of GBP1200?).
Can anyone suggest a source for a refurbished and certified part?
Would be most grateful for any assistance.
Regards
 |
International Comanche Society A maintenance forum for ICS members to share knowledge and learn about their Comanche. Problems? - Contact Administrator at: Webmaster |
Shimmy Damper
5 posts
• Page 1 of 1
Shimmy Damper
by Tidders » Mon Apr 10, 2017 6:13 pm
- Tidders
- ICS member
- Posts: 10
- Joined: Thu May 14, 2009 11:39 am
Re: Shimmy Damper
by LeWayne Garrison » Mon Apr 10, 2017 8:05 pm
Airparts Of Lockhaven Co. use to have them, and I think they still do. Webco in Newton, KS may also.
- LeWayne Garrison
- Posts: 73
- Joined: Tue Aug 16, 2011 3:37 am
Re: Shimmy Damper
by Tidders » Mon Apr 10, 2017 8:59 pm
Thanks for the prompt reply and also the reply to the u/c switch question - much appreciated.
Mike
Mike
- Tidders
- ICS member
- Posts: 10
- Joined: Thu May 14, 2009 11:39 am
Re: Shimmy Damper
by Clarence Beintema » Sun Apr 16, 2017 1:35 pm
There is a simple STC which allows for adding a filler port to the old shimmy damper. Then new fluid can be added as needed. It is held by Aircraftdoorseal.com
Clarence
Clarence
- Clarence Beintema
- ICS member
- Posts: 134
- Joined: Tue May 11, 2010 11:41 pm
Re: Shimmy Damper
by Tidders » Mon Apr 17, 2017 7:28 pm
Thank you Clarence - wasn't aware of that.
Will have a look at the STC.
Mike
Will have a look at the STC.
Mike
- Tidders
- ICS member
- Posts: 10
- Joined: Thu May 14, 2009 11:39 am
5 posts
• Page 1 of 1
Return to Maintenance - Airframe
Who is online
Users browsing this forum: No registered users and 2 guests