Instrument panel

by **Todd Skalsky** » Sun Jan 26, 2014 6:29 pm

Hi all,

I am wanting to install an engine monitor and am wondering if the panel in my 63 250 is two piece. I want to take the old tach and all gauges out but don't want to redo the whole panel at this time. Any advice will be appreciated.

Thanks,

Todd Skalsky

by **N3322G** » Mon Jan 27, 2014 1:26 am

Todd,

Depending upon what model you buy, it may or may not be STC'd to replace the gauges.

For our Twin, the JPI just took a slot and the panel was cut a little to accommodate. Ours is also a two piece.

by **VANBLADEREN** » Mon Jan 27, 2014 2:36 am

Your panel is really one piece with a floating section over the pilots yoke. You cannot remove the rest of the panel without cutting it away. I do not know what you have in your panel now, but if you can get it somewhere on pilots side somewhere, you would be most happy.

Regards

jvb

by **N3322G** » Mon Jan 27, 2014 3:19 pm

Todd,

If you don't already know it, JVB is in the business of doing fabulous panels.

by **Todd Skalsky** » Fri Jan 31, 2014 12:34 am

Thanks for the information. I will check JVB out

Todd

Instrument panel

Instrument panel

Re: Instrument panel

Re: Instrument panel

Re: Instrument panel

Re: Instrument panel

Who is online