 |
International Comanche Society A maintenance forum for ICS members to share knowledge and learn about their Comanche. Problems? - Contact Administrator at: Webmaster |
Horn Inspection
2 posts
• Page 1 of 1
Horn Inspection
by Tom Gillespie » Mon May 02, 2011 8:42 pm
No cracks found in my horn on my 1959 250 comanche, could someone tell me the correct torque specs for the horn bolts, stabilator bolts, and the bearing block bolts, also where do you get a torque wrench that goes down to 60 inch pounds.
- Tom Gillespie
- ICS member
- Posts: 1
- Joined: Mon Feb 23, 2009 2:50 am
Re: Horn Inspection
by 9089P » Tue May 03, 2011 5:33 am
Hi,
Torque wrench is easy, Sears. Or if that doesn't work for you, any bike shop will have such a torque wrench, and if you want to buy one go on line and look for Park Tools for a torque wrench. I got mine a Sears however.
Good luck, Don
PS The person to answer your other question is Trojan Flyer who is on this forum as well as the COF.
Torque wrench is easy, Sears. Or if that doesn't work for you, any bike shop will have such a torque wrench, and if you want to buy one go on line and look for Park Tools for a torque wrench. I got mine a Sears however.
Good luck, Don
PS The person to answer your other question is Trojan Flyer who is on this forum as well as the COF.
- 9089P
- ICS member
- Posts: 426
- Joined: Wed Jan 07, 2004 7:01 am
2 posts
• Page 1 of 1
Return to Maintenance - Airframe
Who is online
Users browsing this forum: No registered users and 0 guests