Best settings for MPG?

Best settings for MPG?

Postby N8632Y » Fri Aug 20, 2010 12:47 am

To anyone who likes numbers:
Went out today and played w/ rpm settings and MPG (miles per gallon) as found on my JPI 760 w/ FF
MP 21.5 RPM 2500 IAS 140 kts 9.2 MPG
then i just moved prop back 100 and let MP do it's thing
MP 22.0 RPM 2400 IAS 140 kts 9.4 MPG
MP 22.5 2300 142 kts 9.7 MPG
MP 23.0 2200 145 kts 9.9 mpg
MP 23.5 2100 138 kts 10.0 mpg
approximations, numbers were fluctuating, and I should have pulled up fuel flow for comparison too....numbers when compared w/ book show approximately same percent horsepower, and i bet FF was similar, but i wonder?
Next time i'll re run and note FF.
steve
PA30-1773 N8632Y
User avatar
N8632Y
ICS member
ICS member
 
Posts: 208
Joined: Wed May 19, 2004 3:56 pm
Location: N14 South Jersey

Postby N3322G » Fri Aug 20, 2010 10:11 am

In aviation consumer about 2 years ago there was a chart on aircraft and car miles per gallon. It was hard to tell under what conditions the data was created so I watched the Shadin FF on the next flight in the MPG setting. I like to fly fast and at 24/24 the Twin consumes gas like a Lincoln Navigator ... but it looks much better.

Fun to watch as the winds changed.
Pat

Patricia Jayne (Pat) Keefer ICS 08899
PA-39 #10 Texas
User avatar
N3322G
ICS member
ICS member
 
Posts: 1911
Joined: Thu May 08, 2008 1:58 pm
Location: Fort Worth, Texas area

Postby N8632Y » Sat Aug 21, 2010 6:55 pm

i hope to get up this week and rerun the test, by:
climb to altitude, where MP can no longer climb, maybe 7500, and run the test, WOT, 2100-2500 RPM, and record speed, MPG, Fuel Flow, and temps on 1 cylinder. This will test at a normal cruise, like a trip profile, which is my best setting.
steve
PA30-1773 N8632Y
User avatar
N8632Y
ICS member
ICS member
 
Posts: 208
Joined: Wed May 19, 2004 3:56 pm
Location: N14 South Jersey

Postby Tony Scarpelli » Sun Aug 22, 2010 10:04 pm

This is a really good thread. I have a 250 and found that 26/2300 is the best highspeed cruise setting and keeping 2"-3" difference between MP and RPM dropping them down to 23/2100rpm is an excellent low power cruise setting.
Tony Scarpelli
ICS member
ICS member
 
Posts: 111
Joined: Thu May 08, 2008 11:47 am

Postby N8632Y » Tue Aug 31, 2010 6:35 pm

PA30-1773 N8632Y
User avatar
N8632Y
ICS member
ICS member
 
Posts: 208
Joined: Wed May 19, 2004 3:56 pm
Location: N14 South Jersey

Postby Tony Scarpelli » Thu Sep 02, 2010 11:58 pm

Tony Scarpelli
ICS member
ICS member
 
Posts: 111
Joined: Thu May 08, 2008 11:47 am

Postby MV Case Jr » Thu Sep 09, 2010 3:11 am

MV Case Jr
ICS member
ICS member
 
Posts: 56
Joined: Thu May 29, 2008 3:41 am

Postby N8632Y » Thu Sep 09, 2010 11:52 am

PA30-1773 N8632Y
User avatar
N8632Y
ICS member
ICS member
 
Posts: 208
Joined: Wed May 19, 2004 3:56 pm
Location: N14 South Jersey


Return to ICS General Membership Discussions

Who is online

Users browsing this forum: No registered users and 23 guests