International Comanche Society

A maintenance forum for ICS members to share
knowledge and learn about their Comanche.

Problems? - Contact Administrator at: Webmaster

Stabilator cable tension PA30 question

Post a reply

Stabilator cable tension PA30 question

Postby Greg Banfield » Thu Feb 11, 2016 5:18 am

Anyone know what the stabilator tension should be for a PA 30 with a Stec 55x installed. PA 30 manual states 18 lbs +\- 20% without auto pilot bridle cables installed.
Last edited by Greg Banfield on Thu Feb 11, 2016 1:48 pm, edited 1 time in total.
Greg Banfield
ICS member
ICS member
 
Posts: 21
Joined: Wed Oct 14, 2009 3:57 pm
Location: Florida
Top

Re: Stabilator cable tension PA30 question

Postby Kristin Winter » Thu Feb 11, 2016 6:45 am

You would need the STEC-55 manual to know for sure, or you can call them. The Century manual is the same as the Piper manual, so I am guessing that if you use those values, you will not be too far off.
Kristin
User avatar
Kristin Winter
ICS member
ICS member
 
Posts: 1299
Joined: Tue Aug 09, 2005 5:21 pm
Location: Northern California
Top

Re: Stabilator cable tension PA30 question

Postby Greg Banfield » Thu Feb 11, 2016 1:49 pm

Thanks... I'll give stec a call to verify.
Greg Banfield
ICS member
ICS member
 
Posts: 21
Joined: Wed Oct 14, 2009 3:57 pm
Location: Florida
Top

Re: Stabilator cable tension PA30 question

Postby Greg Banfield » Thu Feb 11, 2016 5:22 pm

Kristin- You were correct. STEC tech said stabilator cable tension is set to airplane spec per service manual (18 +/- 20%) for PA30. No variation is needed. AP bridle cable should be set to 15 +/- 2 lbs

gb
Greg Banfield
ICS member
ICS member
 
Posts: 21
Joined: Wed Oct 14, 2009 3:57 pm
Location: Florida
Top
Post a reply

Return to Maintenance - Airframe

Who is online

Users browsing this forum: No registered users and 25 guests

Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
cron