Might anyone have the Camloc Part Number for the Camloc Studs that hold down the Emergency Gear floor cover and the Fuel Drain cover in a PA30 cockpit?
The Piper part number is 487-668, and the Piper PA30 Parts catalog mentions Camloc.
From the measurements I took, I believe the Camloc Style is P/N V26S22-???. What I need is the LENGTH (the Camloc "-S" number).
The Piper part is available online for about $65 EACH! The Camloc cost is under $5.
Thanks
 |
International Comanche Society A maintenance forum for ICS members to share knowledge and learn about their Comanche. Problems? - Contact Administrator at: Webmaster |
PA30 Camloc Part Number
2 posts
• Page 1 of 1
PA30 Camloc Part Number
by Frank Brunot » Thu Dec 31, 2015 4:37 pm
- Frank Brunot
- ICS member
- Posts: 91
- Joined: Tue Jun 24, 2008 4:41 pm
- Location: Spring Hill, FL
Re: PA30 Camloc Part Number
by JIMICS2452 » Thu Dec 31, 2015 6:15 pm
http://www.skybolt.com/
They make "camlock" fasteners. Check out their catalog to find the one you need - both style and part number. The should be under $100. Don't forget to order a special washer to hold it in place.
It is probably an SK2600 folding wing series part. The dash number specifies the length of the stud. Page 9 of the catalog.
Webco also stock them.
They make "camlock" fasteners. Check out their catalog to find the one you need - both style and part number. The should be under $100. Don't forget to order a special washer to hold it in place.
It is probably an SK2600 folding wing series part. The dash number specifies the length of the stud. Page 9 of the catalog.
Webco also stock them.
Jim Hiatt
-
JIMICS2452 - ICS member
- Posts: 254
- Joined: Sat Mar 09, 2002 9:26 pm
- Location: Pine Shadows Airpark - North Fort Myers, FL
2 posts
• Page 1 of 1
Return to Maintenance - Airframe
Who is online
Users browsing this forum: No registered users and 10 guests