Oil pressure check

Oil pressure check

Postby Bryan Burnette » Tue Feb 12, 2013 8:40 pm

My left engine is showing a little higher oil pressure than I like. Is there a convenient place to put a pressure gauge to check pressure. I need to see if it is actually high pressure or an indicator issue. Engine is Lyc. IO-360 in a PA-30 Miller.

Thanks,

Bryan
Bryan Burnette
 
Posts: 15
Joined: Thu Oct 11, 2012 6:57 pm

Re: Oil pressure check

Postby N3322G » Tue Feb 12, 2013 10:31 pm

Bryan, I commiserate with your question - good news, bad news on having two engines.

It was a reading like this on oil temp that nudged me to put in the JPI and extra the oil temp probes. At take-off they are very close to redline and after about 10 minutes they decline to green then the left one slides towards the bottom, right one stays in the middle and yet the JPI oil temp stuff is steady... after the probes got installed correctly. Too bad there isn't an oil pressure thing on it - at least not the one we have.
When the gauges were new in 1970 all read the same for both engines. First to go wonky were the fuel gauges.

I'll be interested to learn what other folks post on this.
Pat

Patricia Jayne (Pat) Keefer ICS 08899
PA-39 #10 Texas
User avatar
N3322G
ICS member
ICS member
 
Posts: 1911
Joined: Thu May 08, 2008 1:58 pm
Location: Fort Worth, Texas area


Return to Maintenance - Powerplant

Who is online

Users browsing this forum: No registered users and 21 guests

cron