tachometerws

tachometerws

Postby bernard nowlen » Tue Nov 20, 2012 11:34 pm

Is the an STC to put an electric, dual needle, tach in a pa-30/39. Vans sells a unit that attaches to the accessory case at the mechanical tach drive that acts as a "tach generator". You screw the unit on to your mechanical tach drive housing and the shaft goes where the origingfal one was and it drives some sort of transduser that provides rpm infor for the tach. Most 6 cylinder beech/cessna/piper twins have a pad for a tach generator on the accessory case but not the 4 cylinder O-320's.
bernie
bernard nowlen
 
Posts: 79
Joined: Sat Jun 02, 2012 3:52 pm

Re: tachometerws

Postby N3322G » Wed Nov 21, 2012 12:24 am

There are digital tachs STC'd for Twins - sorry I do not have a reference website

Thought it was Horizon - saw in the Tips that Piper made one also.
Pat

Patricia Jayne (Pat) Keefer ICS 08899
PA-39 #10 Texas
User avatar
N3322G
ICS member
ICS member
 
Posts: 1911
Joined: Thu May 08, 2008 1:58 pm
Location: Fort Worth, Texas area

Re: tachometerws

Postby bernard nowlen » Wed Nov 21, 2012 1:11 am

I had one 3 1/8" electric dual needle electrical tack on all the cessna/beech/aerocommander 6 cylinder twins i've owned. I'm going to upgrade the panel to Ron & Johns commanchde service new style panel and want to move the dual engine tach,map,ff to the left panel next to the center stack radio set up. I don't think the mechanical tack drive cable for the right engine will be long enough to accomidate the move, even though the parts manual says they are both 146" long.
Ideas ?
bernie
bernard nowlen
 
Posts: 79
Joined: Sat Jun 02, 2012 3:52 pm


Return to Maintenance - Powerplant

Who is online

Users browsing this forum: No registered users and 21 guests

cron