I have a 250 with the Tip Tanks. Just doing an updated weight and Balance. Is the Arm on the Tip Tanks the same as the Mains? If different where can I find this Information?
Bill
 |
International Comanche Society A maintenance forum for ICS members to share knowledge and learn about their Comanche. Problems? - Contact Administrator at: Webmaster |
Tip Tank ARM
3 posts
• Page 1 of 1
Tip Tank ARM
by William Mattson » Tue Nov 20, 2012 6:46 pm
- William Mattson
- Posts: 63
- Joined: Sun Nov 06, 2011 7:23 pm
Re: Tip Tank ARM
by Hank Spellman » Tue Nov 20, 2012 8:31 pm
Years ago I asked Larry Larkin the same question. He looked it up in some information he had on the 260C, the only single model that came from the factory with tip tanks. For the 260C, the arm is 90.50 inches. If the arm on your mains is 90.00, then the arm on the tips is 90.50. I don't know about the twins, but I would bet it is the same.
Look in the type data sheet for the 260C, and in the STC or installation instructions for the tip tanks.
Hank
Henry A. Spellman
Look in the type data sheet for the 260C, and in the STC or installation instructions for the tip tanks.
Hank
Henry A. Spellman
-
Hank Spellman - Moderator
- Posts: 120
- Joined: Thu Jan 20, 2000 3:13 am
- Location: Lincoln, IL
Re: Tip Tank ARM
by N3322G » Tue Nov 20, 2012 10:32 pm
Bill,
If you have old W & B from the tip tank install, it should be there in your POH.
If you have old W & B from the tip tank install, it should be there in your POH.
Pat
Patricia Jayne (Pat) Keefer ICS 08899
PA-39 #10 Texas
Patricia Jayne (Pat) Keefer ICS 08899
PA-39 #10 Texas
-
N3322G - ICS member
- Posts: 1911
- Joined: Thu May 08, 2008 1:58 pm
- Location: Fort Worth, Texas area
3 posts
• Page 1 of 1
Return to Maintenance - General
Who is online
Users browsing this forum: No registered users and 47 guests