Part ID

Part ID

Postby William Mattson » Tue Oct 02, 2012 3:37 am

Getting my plane ready for Annual (1963 PA24-250). I'm getting to know her better now. I was looking where the main spars connect and there are 2 large cables (approx 3/8") attached to the connector plate that head out towards the wings. I looked it the Parts catalog, but did not see it. Just curiosity, but what is it.
William Mattson
 
Posts: 63
Joined: Sun Nov 06, 2011 7:23 pm

Re: Part ID

Postby Kristin Winter » Tue Oct 02, 2012 3:51 am

If they go from the center of the fuselage in front of the spar, and then each curves out to a wing, you are looking at the main landing gear push-pull conduits.
Kristin
User avatar
Kristin Winter
ICS member
ICS member
 
Posts: 1299
Joined: Tue Aug 09, 2005 5:21 pm
Location: Northern California

Re: Part ID

Postby md11flyer » Tue Oct 02, 2012 4:02 am

William, those are your landing gear conduits.
If they are green / blueish in colour then they are the upgraded conduits and if they are metal
then they are original style. Have your A&P closely check the log book for any replacement of these conduits. If they are original then depending on the size of your wallet have these replaced proactively. The conduits are about 400 dollars a piece and should be replaced by a knowledgable Comanche A&P. Not saying that only they can change them, Its just one of those jobs that can take three times as long doing it the first time.... also the setting of the limits switches are very important to get right. Once again anybody can do it from the service manual, but it must be done right for your gear to be safe.

Good that you are digging in there with the annual, its always good to get extra knowledge of the inner workings of these
birds.

Good Luck,

Gary
md11flyer
ICS member
ICS member
 
Posts: 330
Joined: Tue Mar 24, 2009 3:48 pm


Return to Maintenance - General

Who is online

Users browsing this forum: No registered users and 44 guests

cron