 |
International Comanche Society A maintenance forum for ICS members to share knowledge and learn about their Comanche. Problems? - Contact Administrator at: Webmaster |
comanche 400 starter
3 posts
• Page 1 of 1
comanche 400 starter
by MARVIN DYER » Sun Dec 04, 2011 2:20 am
where do you find the 24 volt starting conversions for a comanche 400
- MARVIN DYER
- Posts: 8
- Joined: Sun Dec 04, 2011 1:43 am
Re: comanche 400 starter
by Gil Dahl » Sun Dec 04, 2011 8:10 pm
Marvin
When I purchased my 400, 33 years ago , one of the first things I did was REMOVE the 24 volt Starting system and have never regretted it. There are far better ways to correct the HOT STARTING problem. But if you are interested I probably still have the required special switch. Give me a call @ 480 595-0511.
Gil Dahl N400SW
When I purchased my 400, 33 years ago , one of the first things I did was REMOVE the 24 volt Starting system and have never regretted it. There are far better ways to correct the HOT STARTING problem. But if you are interested I probably still have the required special switch. Give me a call @ 480 595-0511.
Gil Dahl N400SW
- Gil Dahl
- ICS member
- Posts: 6
- Joined: Thu Sep 01, 2005 12:50 am
Re: comanche 400 starter
by IO720 » Wed Dec 14, 2011 5:41 am
Try a lightweight, B+C Starter. Not only spins faster and uses a lot less amps, but you'll save about 15 pounds off of the nose.
Rick Mascari
N64400
Rick Mascari
N64400
- IO720
- ICS member
- Posts: 38
- Joined: Thu Apr 21, 2005 11:36 pm
3 posts
• Page 1 of 1
Return to Maintenance - General
Who is online
Users browsing this forum: No registered users and 12 guests