 |
International Comanche Society A maintenance forum for ICS members to share knowledge and learn about their Comanche. Problems? - Contact Administrator at: Webmaster |
Fuel sending units... New vs. Rebuilt
2 posts
• Page 1 of 1
Fuel sending units... New vs. Rebuilt
by Chic Ritzheimer » Fri Jun 04, 2010 1:15 am
Going to replace all the bladders on the 250 I am buying next week, does anyone have any input on the sending units? If I'm going to the expense of bladders, I might as well go for the sending units too. Where do you go to have them rebuilt or trade in for new ones? Thanks again, Chic
-
Chic Ritzheimer - ICS member
- Posts: 40
- Joined: Sun May 23, 2010 3:56 pm
- Location: KDVT
sending units
by Doug David » Fri Jun 04, 2010 6:00 am
I sent one to Webco when I had a my fuel cell out a few weeks ago. I think it cost around $135 to repair it. Check it with an ohm meter first, it should read 0 to 30
-
Doug David - ICS member
- Posts: 22
- Joined: Wed May 20, 2009 1:17 pm
2 posts
• Page 1 of 1
Return to Maintenance - General
Who is online
Users browsing this forum: No registered users and 56 guests