Fuel draining is a drag when you're alone

Postby Zach Grant L1011jock » Wed Apr 01, 2009 1:17 pm

Effie,
Get some tamper evidentseals, and seal your fuel doors after fill up. See if the problem persists...:-)
-Zach
"Keep it above 5 feet and don't do nuthin dumb!"
User avatar
Zach Grant L1011jock
Technical Advisor
 
Posts: 1404
Joined: Mon Mar 22, 2004 4:35 pm
Location: Indianapolis KEYE

Postby ics-12766 » Wed Apr 01, 2009 3:00 pm

Effie, you and your fellow owners can get together and buy a motion sensing camera with invisible IR flash. Solve the mystery once and for all :)

http://www.cabelas.com/cabelas/en/commo ... jsp.form23
Rich Clover
User avatar
ics-12766
ICS member
ICS member
 
Posts: 277
Joined: Fri Oct 22, 2004 6:10 am
Location: Evanston, WY (KEVW)

Postby Effie Andree Wiltens » Wed Apr 01, 2009 5:22 pm

Zach,
I had a look at the labels. It's an interesting idea, but only workable when we don't open the seal ourselves to inspect the tank. Fuel isn't necessarily disappearing at the first opportunity.
Maybe we'll go for the hair-across-the-surface spy trick.
For now, I've put a notepaper inside the door on top of the filler caps : THEFT IS ILLEGAL AND WILL BE PUNISHED. And we've an agreement among ourselves to always position the caps in such-and-such a way. Meanwhile we're dipstick checking when we put the plane to bed and again before the next flight. The record wil show, or not.

There's an item in the Tips manual about installing locks. That's useful anyway when you're visiting places with bad airfield security. We weren't expecting this sort of thing on our home turf, however!

As for the camera, there's a lot of legitimate movement in the hangar. The plane also gets moved around to get other planes in and out, making it difficult to aim the camera's line of sight. Mounting on the aircraft itself creates its own logistical nightmare.

The best we can do for now is to keep a good record of our dipstick measurements.
User avatar
Effie Andree Wiltens
ICS member
ICS member
 
Posts: 89
Joined: Sun Jan 04, 2009 4:39 pm
Location: Netherlands

Postby Effie Andree Wiltens » Wed Apr 01, 2009 5:53 pm

I had another look at the seals option. They do offer a solution that is workable and it's not too expensive. Except that the shipping multiplies the cost by a factor of 4, adding a ridiculous $60-80 to an order of $25. Unfortunately, I'm not planning to be in the USA in the foreseeable future.
User avatar
Effie Andree Wiltens
ICS member
ICS member
 
Posts: 89
Joined: Sun Jan 04, 2009 4:39 pm
Location: Netherlands

Postby howard » Sun Apr 05, 2009 1:57 pm

tip tanks can drain into mains in a big way!.
aux can also move to mains.
I have had fuel pouring all over the place on a tip tank equipped single. I had to turn the selectors off.
a hill on the ramp, along with a passing selector will make it even more fun.
I sure hope noone is stealing it , mind you I also hope your selectors are not passing!!
Howard
howard
ICS member
ICS member
 
Posts: 49
Joined: Sat Jun 29, 2002 3:11 am
Location: Kincardine Ontario

Postby Effie Andree Wiltens » Mon Apr 06, 2009 5:28 pm

Being new to the Comanche, I'm still in the gathering data phase. Nothing gets discounted, nothing assumed. I've heard that there can be flow through the spider/selector arrangement. We don't mind flow so much as long as fuel doesn't get lost. The main gauges are totally unreliable as indicators.
We dipstick measure all tanks before each flight and tote everything up, and compare that total with the previous post-flight total. People have observed us doing this, it might even serve as a deterrant to know that we keep careful watch.
There's an item in the Tips about locks on the doors, but the pictures are not clear. I'd hate to regret a messy job, this has to be done right or not at all.
User avatar
Effie Andree Wiltens
ICS member
ICS member
 
Posts: 89
Joined: Sun Jan 04, 2009 4:39 pm
Location: Netherlands

Postby Jay » Mon Apr 06, 2009 7:34 pm

Jay
PA 30 N7702Y
User avatar
Jay
ICS member
ICS member
 
Posts: 473
Joined: Tue Sep 30, 2003 10:59 pm
Location: Portland, Oregon

Previous

Return to ICS General Membership Discussions

Who is online

Users browsing this forum: No registered users and 7 guests

cron