Recent brake reversal paper work

[Billy Dennis]

Does anyone have a recent 337 signed off by the feds that I could get a copy of. Wanting to change brakes to the inside on my 180. Thanks
Billy

[MULEFLY]

I think if you go over to the Delphi site.... there is a folder there of 337s and you may find one in there.

All the best!
Jim

[Billy Dennis]

Thanks JIm,

I will go take a look and see if something recent is there.

Billy

[Dale Vandever]

Billy, here is Hans' post from the Comanche Owner's FORUM.

Contact him for a complete copy. You may want to check the Pathfinder to verify current eMAil address.

Dale

From: HANSMEISTER 11/5/2002 5:04 pm
To: halerd (13 of 20)

2426.13 in reply to 2426.12

Everyone that desires to get a copy of one or all of the following:
1. Brake Reversal 337.
2. 3rd Seat Belt for Bench Seat 337.
3. Jack Stand Drawing.

I need a physical address to send copies. Forward you mailing address to me at hansn@pciaerospace.com

The two 337's come with a report, drawings and stress analysis as approved data. They are not in a modern electronic format (done too many years ago in Volkswriter).

The Jack Stand drawing is a D size format drawing done in CadKey. Unless you have CadKey, you won't be able to open it.

I will scan the two 337 packages, and upload for inclusion to the new ComanchePilot web site.

As of now, I have ChucknEddie for the jack drawing, and GPly and Halerd for the brake reversal.



--------------------------------------------------------------------------------
Edited 11/5/2002 6:05:40 PM ET by HANSMEISTER

[Billy Dennis]

Thanks Dale !!

[MULEFLY]

Han's email address is incorrect above (he retired... but I think he still does some consulting with them...)

Anyway try this one:
hdneubert@sbcglobal.net

I have received mail from him in the last several weeks where he used that address.

Jim

[Billy Dennis]

Thanks Jim!

[Hansmeister]

I have the brake reversal and third seat belt information scanned, and available to any ICS member.

Just send an e-mail with your ICS number to: hdneubert@sbcglobal.net

[pa24-250]

Are you reversing the brakes so They wont hang down. If this is the reason how much will it speed you up?
Kevin

[Hansmeister]

The combination of brake reversal, K2U Gear Lobes, and split hubcaps will get you 5 mph.

Your paperwork was sent earlier this evening.

[WMD]

Hans,
Sent you an email requesting the paperwork for these modifications.
Thanks,
Bill