Hans,
What does that do for the discs, and where does one get it done?
 |
International Comanche Society A maintenance forum for ICS members to share knowledge and learn about their Comanche. Problems? - Contact Administrator at: Webmaster |
Bolt on Brake Discs
6 posts
• Page 1 of 1
Bolt on Brake Discs
by Zach Grant L1011jock » Fri Nov 21, 2008 8:48 pm
"Keep it above 5 feet and don't do nuthin dumb!"
-
Zach Grant L1011jock - Technical Advisor
- Posts: 1404
- Joined: Mon Mar 22, 2004 4:35 pm
- Location: Indianapolis KEYE
by Hansmeister » Sat Nov 22, 2008 4:43 am
-
Hansmeister - ICS member
- Posts: 802
- Joined: Thu Jun 27, 2002 5:44 pm
- Location: Kah-li-forn-yah
by Hansmeister » Sun Nov 23, 2008 6:59 pm
At Matt Kurke's suggestion, I looked into this by a Google search and found that all hot rodder's do this to their engines, brakes, anything that wears.
It is some sort of process that heats the metal, and then subjects the part to about -320F (liquid nitrogen), and creates a very hard surface, resistant to wear.
I found a place in Oceanside. He picked them up as part of his route, and had them back in two days. Cost was $50 for both.
Do a Google on "cryo treatment" and see what you find.
It is some sort of process that heats the metal, and then subjects the part to about -320F (liquid nitrogen), and creates a very hard surface, resistant to wear.
I found a place in Oceanside. He picked them up as part of his route, and had them back in two days. Cost was $50 for both.
Do a Google on "cryo treatment" and see what you find.
-
Hansmeister - ICS member
- Posts: 802
- Joined: Thu Jun 27, 2002 5:44 pm
- Location: Kah-li-forn-yah
by Jeffrey Barrett » Fri Mar 27, 2009 6:37 pm
- Jeffrey Barrett
- ICS member
- Posts: 9
- Joined: Tue Feb 24, 2009 5:05 pm
-
Zach Grant L1011jock - Technical Advisor
- Posts: 1404
- Joined: Mon Mar 22, 2004 4:35 pm
- Location: Indianapolis KEYE
6 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 19 guests