Gear Bungie Opinion

Re: Gear Bungie Opinion

Postby LeWayne Garrison » Thu Jul 28, 2016 9:37 pm

Zach is correct in stating that the gear is held down by "over-center". The springs and bungees do help hold the gear over-center. I agree the springs are important. However PA24's flew several years and many hours before Piper mandated the second spring and bungee change intervals. (From the late 1950's until 1977, in the case of the bungees). That said, I have literally seen aircraft brought in where the bungees are laying loose on the inspection plate (just hanging). Not because they were worn out, but because they were incorrectly installed 3 years prior by a different shop. Given correct landing technique and the electric gear system functioning properly, a Comanche can be landed almost innumerable times without the bungees. Mind you, I'm no advocating that, just stating what I've seen. If you read the AD 77-13-21 it states the purpose of the bungee change interval and the bushing wear check is to prevent gear collapse when manual extension is used. The nose gear springs also serve to keep the gear down and work in much the same way as the bungees. The gear system works in concert, the springs (originally a nose gear bungee), the main gear bungees and the motor and transmission all help the gear stay over center and "down and locked". But the important take-home message is this: If you only check one thing on the Comanche gear, BE SURE IT GOES OVER CENTER.

To restate the opinion on how often to change bungees, that is up to the owner. The FAA and Piper Aircraft recommend every 3 years or 500 hours. As an IA, that is good enough for me.
LeWayne Garrison
 
Posts: 73
Joined: Tue Aug 16, 2011 3:37 am

Re: Gear Bungie Opinion

Postby Kristin Winter » Fri Jul 29, 2016 3:09 am

The point of the bungees is overwhelmingly to reduce the load on the transmission during retraction. As was pointed out in the previous post, they have little affect on the over-center. Even in an emergency extension, the gear is held down by the solid link between the nose gear strut, through the drag links and through the push-pull rod. It is the nose springs that keep the nose gear drag links over-center.

Since the bungees job is to unload the transmission, and bungees are cheap, and transmissions are expensive, I recommend to all owners with whom I do an annual that we replace the bungees and that it be done every year. They lose a noticeable amount strength even in one year. Did I mention that transmissions, or their overhaul, is expensive. :D
Kristin
User avatar
Kristin Winter
ICS member
ICS member
 
Posts: 1299
Joined: Tue Aug 09, 2005 5:21 pm
Location: Northern California

Previous

Return to Maintenance - Airframe

Who is online

Users browsing this forum: No registered users and 31 guests