I am having trouble with the single fork mod on my 64 PA30. The wheel spacers are different and the axle nut does not seem to fit against the bearing properly. Does anyone have the length of the spacer required or an idea how to fix the axle nut issue?
Thanks!
Skip
 |
International Comanche Society A maintenance forum for ICS members to share knowledge and learn about their Comanche. Problems? - Contact Administrator at: Webmaster |
Single fork conversion
2 posts
• Page 1 of 1
Single fork conversion
by Skip Stewart » Sun Sep 21, 2014 12:43 am
- Skip Stewart
- ICS member
- Posts: 2
- Joined: Sat Nov 01, 2008 1:26 am
Re: Single fork conversion
by Zach Grant L1011jock » Mon Sep 22, 2014 3:05 pm
Skip,
Give Phil a call a Webco and ask him. He might have that measurement right on the top of his head. The criticle dimension is the spacer between the fork and the wheel so that the disk clears the fork. Once you have that dimension, then you can do whatever you need to do to add spacers (shims) to the outboard side of the axle so that the axle nut seats properly in the range it can be pinned.
-Zach
Give Phil a call a Webco and ask him. He might have that measurement right on the top of his head. The criticle dimension is the spacer between the fork and the wheel so that the disk clears the fork. Once you have that dimension, then you can do whatever you need to do to add spacers (shims) to the outboard side of the axle so that the axle nut seats properly in the range it can be pinned.
-Zach
"Keep it above 5 feet and don't do nuthin dumb!"
-
Zach Grant L1011jock - Technical Advisor
- Posts: 1404
- Joined: Mon Mar 22, 2004 4:35 pm
- Location: Indianapolis KEYE
2 posts
• Page 1 of 1
Return to Maintenance - Airframe
Who is online
Users browsing this forum: No registered users and 6 guests