 |
International Comanche Society A maintenance forum for ICS members to share knowledge and learn about their Comanche. Problems? - Contact Administrator at: Webmaster |
NSD 360 Install
3 posts
• Page 1 of 1
NSD 360 Install
by PJACKO » Fri Oct 04, 2013 11:37 pm
I`m putting in a slaved NSD 360A and the pinouts I have for the slaving amp are for a IC755 with bootstrap but I have a IC714 slaving amp, is the plug CD 115 wired the same on both? If any one has the pinout print for a IC714 if you could email it to me I would really appreciate it. THANKS EMAIL- jknfr90@gmail.com
- PJACKO
- ICS member
- Posts: 10
- Joined: Thu Sep 04, 2003 1:55 am
Re: NSD 360 Install
by VANBLADEREN » Sat Oct 05, 2013 8:51 am
http://www.centuryflight.com/services/t ... -list.html
Hi, the above is the link to Century flight systems and the schematics for the pieces you are looking for are there. I am johnv@spiretech.com if you have any questions. I am overseas now until the 6th of October. I have a composite PDF of the wiring at home as I have done this a few times.
regards
jvb
Hi, the above is the link to Century flight systems and the schematics for the pieces you are looking for are there. I am johnv@spiretech.com if you have any questions. I am overseas now until the 6th of October. I have a composite PDF of the wiring at home as I have done this a few times.
regards
jvb
- VANBLADEREN
- ICS BOD member
- Posts: 203
- Joined: Fri Jun 01, 2001 8:55 pm
Re: NSD 360 Install
by PJACKO » Sat Oct 05, 2013 2:57 pm
Thanks John. That was the print I needed.
Jack
Jack
- PJACKO
- ICS member
- Posts: 10
- Joined: Thu Sep 04, 2003 1:55 am
3 posts
• Page 1 of 1
Return to Maintenance - Avionics
Who is online
Users browsing this forum: No registered users and 3 guests