 |
International Comanche Society A maintenance forum for ICS members to share knowledge and learn about their Comanche. Problems? - Contact Administrator at: Webmaster |
fuel quantity gauge
3 posts
• Page 1 of 1
fuel quantity gauge
by Russell Knowles » Sun Sep 13, 2009 7:57 am
I would like to update my 1962 -250's fuel gauge with a more modern gauge. UMA list a TSO gauge which they claim is compatible with the comanche float sender units. [0 - 30 ohms] Has anyone done this modification and could comment on its success?
- Russell Knowles
- ICS BOD member
- Posts: 12
- Joined: Mon May 26, 2008 7:15 am
by AlanBreen » Sun Sep 13, 2009 9:55 am
Hi Russell,
Are you making the change because you current gauges don't read properly? If this is the case might I suggest that the problem is more likely to be the sender unit
Are you making the change because you current gauges don't read properly? If this is the case might I suggest that the problem is more likely to be the sender unit
-
AlanBreen - ICS member
- Posts: 557
- Joined: Thu Jun 27, 2002 6:57 am
- Location: Hamilton, New Zealand
fuel gauge
by Russell Knowles » Sun Sep 13, 2009 11:05 am
Thanks Allan,
No, in fact I have new senders from Matt Kurke and the old gauge is operational but I would like to upgrade the entire panel and the UMA unit at 2 1/4 inch would be much easier to read.
regards
Russell
No, in fact I have new senders from Matt Kurke and the old gauge is operational but I would like to upgrade the entire panel and the UMA unit at 2 1/4 inch would be much easier to read.
regards
Russell
- Russell Knowles
- ICS BOD member
- Posts: 12
- Joined: Mon May 26, 2008 7:15 am
3 posts
• Page 1 of 1
Return to Maintenance - General
Who is online
Users browsing this forum: No registered users and 64 guests