I'm looking to see if anyone here has a DXF file for my 62 180 panel with a center stack. I have a laser so I'm hoping to get a hold of an electronic file I can work with to cut a new set of panels.
Don
 |
International Comanche Society A maintenance forum for ICS members to share knowledge and learn about their Comanche. Problems? - Contact Administrator at: Webmaster |
Panel DXF file?
1 post
• Page 1 of 1
Panel DXF file?
by Donald Shaffer » Sun Feb 05, 2017 12:24 am
- Donald Shaffer
- Posts: 4
- Joined: Sat Jul 02, 2016 10:10 pm
1 post
• Page 1 of 1
Return to Maintenance - General
Who is online
Users browsing this forum: No registered users and 5 guests