 |
International Comanche Society A maintenance forum for ICS members to share knowledge and learn about their Comanche. Problems? - Contact Administrator at: Webmaster |
MP gauge
2 posts
• Page 1 of 1
by Zach Grant L1011jock » Mon Sep 22, 2008 2:52 pm
Kevin,
The copper tubing should not be the cause of your vibration. If you have needle pulsing, then the dampning screw on the MP guage needs to be tightened a bit (it is inside the fitting on the back of the instrument). If your whole guage is vibrating, then you have some excessive airframe vibration, and it would brorbably be a good idea tothink about new engine mount rubbers, and a dynamic prop balance.
-Zach
The copper tubing should not be the cause of your vibration. If you have needle pulsing, then the dampning screw on the MP guage needs to be tightened a bit (it is inside the fitting on the back of the instrument). If your whole guage is vibrating, then you have some excessive airframe vibration, and it would brorbably be a good idea tothink about new engine mount rubbers, and a dynamic prop balance.
-Zach
"Keep it above 5 feet and don't do nuthin dumb!"
-
Zach Grant L1011jock - Technical Advisor
- Posts: 1404
- Joined: Mon Mar 22, 2004 4:35 pm
- Location: Indianapolis KEYE
2 posts
• Page 1 of 1
Return to Maintenance - General
Who is online
Users browsing this forum: No registered users and 15 guests