In the twin IPC figure 48 part number 28, the pulley part number is 20534-00. Does anyone know if this is a standard pulley available from Spruce and if so, what is the common part number?
Thanks,
Terry
 |
International Comanche Society A maintenance forum for ICS members to share knowledge and learn about their Comanche. Problems? - Contact Administrator at: Webmaster |
Twin Stabilator Trim Pully Part Number
2 posts
• Page 1 of 1
Twin Stabilator Trim Pully Part Number
by Terry Tibbitts » Sun Mar 16, 2014 8:09 pm
****************
Terry Tibbitts
Blairsville, Georgia
N5806P
PA-24-250
Terry Tibbitts
Blairsville, Georgia
N5806P
PA-24-250
- Terry Tibbitts
- Posts: 14
- Joined: Sat Dec 22, 2012 1:53 pm
Re: Twin Stabilator Trim Pully Part Number
by bernard nowlen » Mon Mar 17, 2014 1:28 am
If you have the dimensions (diameter, gruve(SP) width &depth, bearing hole diameter ) I think you can find them from spruce. They are usually a standard part. bernie
- bernard nowlen
- Posts: 79
- Joined: Sat Jun 02, 2012 3:52 pm
2 posts
• Page 1 of 1
Return to Maintenance - General
Who is online
Users browsing this forum: No registered users and 7 guests