by Daniel Paternoster » Sun Apr 29, 2012 11:28 pm
This week, I swapped an articulating right front seat from a '77 Archer into my '59 PA24 180. It went onto the rails with no problem, had no interference with side wall structures or fuel selector, but the front of the bottom cushion is about an inch higher and the seat sits about four inches farther forward so the rails would need a couple more holes behind the existing holes to let the seat travel back as far as the original seat. The original rails are long enough to allow that adaptation but I haven't run it by a DER yet. Do all the Cherokee seats mentioned in the earlier post have the more forward positioning?