Gear Motor Solenoid

Gear Motor Solenoid

Postby Robert Miller » Tue Mar 13, 2012 11:19 pm

Has anyone had to change a gear motor solenoid which is located in a terrible spot aft of the firewall at the top? Where can a person find a replacement apparently Webco does not have them.

Thanks

Bill
Bill
Robert Miller
 
Posts: 21
Joined: Thu Sep 01, 2011 4:24 am
Location: Alberta

Re: Gear Motor Solenoid

Postby Mark Anderson » Wed Mar 14, 2012 12:27 am

Robert, have you tried Matt Kurke at Comanche Gear ?
User avatar
Mark Anderson
ICS member
ICS member
 
Posts: 196
Joined: Sat Aug 29, 2009 12:24 am
Location: Huntsville , AL

Re: Gear Motor Solenoid

Postby Robert Miller » Wed Mar 14, 2012 2:06 am

Thanks

I have sent Matt a email to see what he has.
Bill
Robert Miller
 
Posts: 21
Joined: Thu Sep 01, 2011 4:24 am
Location: Alberta

Re: Gear Motor Solenoid

Postby Mark Anderson » Wed Mar 14, 2012 3:08 am

Robert, I got one from him about 2 years ago. I replaced mine preemptively when I had a new instrument panel installed. Also replaced the lights and gear switch and wiring. I got all of it from Matt. Hope he can help you out.


Good luck,

Mark
User avatar
Mark Anderson
ICS member
ICS member
 
Posts: 196
Joined: Sat Aug 29, 2009 12:24 am
Location: Huntsville , AL

Re: Gear Motor Solenoid

Postby N8349P » Sat Mar 24, 2012 1:11 am

Bill,

Replaced one about two years ago. They are available from Aviall (Piper). It is called a contactor. I think it was about $85.00. Mine would fail intermittently and blow the low current gear indicator light breaker. Was only able to replicate by inputting vibration to the unit after I removed it from the plane. I dont envy the reinstall. Pull the original and hook up the wires by rolling everything down toward the floor. I had better luck putting the bolts back in toward the front but make sure you have clearance to the brake fluid resevoir.

Doug Pickett
8349P
Doug Pickett
586-264-0786
N8349P
ICS member
ICS member
 
Posts: 35
Joined: Sun Nov 16, 2003 5:39 pm
Location: Sterling Heights, MI

Re: Gear Motor Solenoid

Postby Robert Miller » Tue Mar 27, 2012 4:01 am

Thanks to everyone for the information did find out that Matt had one and also I will able to get one from Prairie Aircraft in Regina Saskatchewan which was in Canada and a overnight on the bus. Apparently it cross references to a Cessna part number as Prairie is a Cessna dealer. It is a challenge to change very time consuming $$$

Regards

Bill
Bill
Robert Miller
 
Posts: 21
Joined: Thu Sep 01, 2011 4:24 am
Location: Alberta


Return to Maintenance - General

Who is online

Users browsing this forum: No registered users and 26 guests

cron