 |
International Comanche Society A maintenance forum for ICS members to share knowledge and learn about their Comanche. Problems? - Contact Administrator at: Webmaster |
Help Please!!! Squat switch actuating lever
8 posts
• Page 1 of 1
Help Please!!! Squat switch actuating lever
by AlanBreen » Mon Jun 09, 2008 12:57 am
-
AlanBreen - ICS member
- Posts: 557
- Joined: Thu Jun 27, 2002 6:57 am
- Location: Hamilton, New Zealand
by jeffrey aryan » Mon Jun 09, 2008 1:19 am
- jeffrey aryan
- ICS member
- Posts: 243
- Joined: Fri Jan 30, 2004 5:21 am
- Location: Chino, CA (So-Cal)
-
Zach Grant L1011jock - Technical Advisor
- Posts: 1404
- Joined: Mon Mar 22, 2004 4:35 pm
- Location: Indianapolis KEYE
by Kristin Winter » Tue Jun 10, 2008 6:47 am
Roll pins, being hollow in the center, should be susceptible to being drilled out. I don't believe them to be of a particularly greater hardness. I would remove the link, and with a drill press drill out the pin, with successively larger drill bits, taking a few thousandth out each time. When I got to the point where the pin was just a thin shell, I would heat the link and then use a small, tapered extactor to remove the last bit.
Kristin
-
Kristin Winter - ICS member
- Posts: 1299
- Joined: Tue Aug 09, 2005 5:21 pm
- Location: Northern California
by Matt Kurke » Thu Jun 12, 2008 5:07 am
-
Matt Kurke - ICS member
- Posts: 43
- Joined: Fri May 09, 2008 11:06 pm
8 posts
• Page 1 of 1
Return to Maintenance - General
Who is online
Users browsing this forum: No registered users and 2 guests